SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS                   REV. 00

www.cobra.it

Note: This information is not binding, therefore it must be considered only an example for  installation purposes that must be executed
as per the instructions given on the product installation manual.

aua698gbb.doc

MAKE

AUDI

MOD.

A6

YEAR

98 

→

→

PETROL
DIESEL

ALARM/SIREN
POSITION

Position the compact alarms and the sirens in the engine compartment, drivers
side.

CENTRAL UNIT POSITION

Position  the modular systems and the modules on the left of the steering column,
drivers side.

POWER SUPPLY

+ 30: connect with a ring terminal to one of the general power supply terminal in
the fuse box.
-  31: connect with a ring terminal directly to the car body.

IGNITION WIRE

+ 15/54: connect to the 1,5 mm

2

 BLUE/BLACK wire at the position nr.4 of the

orange connector nr.15 located on the connectors holder plate behind the left
bulkhead, drivers side.

DIRECTION INDICATORS

Connect to the BLACK/WHITE wires at the position nr.9 and BLACK/GREEN at
the position nr.10 in the 10 way light brown connector located behind the left sill
cover, drivers side.

ELECTRIC WINDOWS

Comfort closing
Negative control signal
The closing of the windows is obtained timing the GREEN/BLUE doors closure
wire of the vehicle.

CENTRAL DOORS LOCKING

Negative control signal
Connect to the GREEN/BLUE wires at the position nr.5 (lock) and
BROWN/YELLOW at the position nr.6 (unlock) located in the 15 way light brown
connector behind the left sill cover, drivers side.

IMMOBILISATION POINT 1

Fuel pump
Cut the 1,5 mm

2 

GREEN/YELLOW wire located at the position nr.32 of the 6 way

light blue connector, near the connector mentioned above.

IMMOBILISATION POINT 2

Fuel pump relay coil supply
Cut the 1,5 mm

2 

GREEN/YELLOW wire located in the wiring harness coming out

of the fuse marked nr.34 in the fuse box.

BONNET SWITCH

Install an additional switch near the left lateral headlamp.

DOORS SWITCH

Connect to the GREEN/YELLOW wires at the position nr.1, RED/GREY at the
position nr.10, BLACK/RED at the position nr.12 and BLACK/VIOLET at the
position nr.14 located in the 16 way light brown connector coming out of the
modular system under the moquette on front of the drivers seat.

BOOT SWITCH

Positive polarity control signal
Connect to the 1 mm

2

 RED/GREEN wire at the position nr.9 located in the 12 way

black connector coming out of the modular system under the moquette on front of
the drivers seat.

X