1995 > G 2.0 DOHC

0x01 graphic

Inspection

1.

With the knock sensor connector still connected, connect a voltmeter between terminal 3 (YEL/GRN) and ground.

2.

Turn the ignition switch ON.

0x01 graphic

3.

Tap the engine crossmember bracket with a wrench.

4.

Verify that a voltage spike (less than 1V) is output from the knock sensor.

5.

If no voltage spike is observed, replace the knock sensor.

Removal

1.

Remove intake manifold support bracket.

2.

Disconnect wire harness.

3.

Loosen bolt and remove sensor.

Installation

1.

Install sensor and tighten bolt.

2.

Install wire harness.

3.

Reinstall intake manifold support bracket.

0x01 graphic